Week 1 Tutorial Exercises

Exercise 1: Draw some points in Rhino. Assign points to grasshopper point component. Draw lines between points with Line AB component.

Exercise 2: Draw a circle in Grasshopper. Control the radius with a slider.

 Exercise 3: Draw a rectangle in Grasshopper. Control the length of one parallel set of edges with a slider. Set the length of the other parallel set of edges as a ratio of the length of the slider controlled edges.

Exercise 4: Draw a curve. Divide the curve into an amount of sections defined by a slider. Place a sphere at each division point.

Exercise 5: Draw two curves in Rhino and loft them in Grasshopper. Move the control points of these curves in Rhino and see how the loft responds.

Exercise 6: Create a 3D representation of your first initial.